Bose Acoustic Wave II CD Changer Información técnica descargar pdf (Pagina 15)

Maintaining Your System

Replacing the remote control battery

If your remote control does not work properly, or its range of operation is reduced, it is time to

replace the battery. Follow the instructions below:

1. Place the remote control face down on a ﬂat surface.

2. Press the tab lock on the battery compartment to the side, as shown (Figure 12a).

3. Hold that tab down as you slide the battery compartment open and remove the battery.

4. Install a new battery, making sure that the positive symbol (+) is facing up as you put the

battery into the compartment (Figure 12b).

Figure 12

Pressing the (a) tab lock

down to remove the (b) bat-

tery compartment

WARNING: Danger of explosion if battery is incorrectly replaced. Replace only with the same

or equivalent type.

Replace only with a lithium CR2032 or DL2032 battery by Duracell, Eveready, Hitachi, Maxell,

or Toshiba (available from most electronics stores).

Mishandling the remote control battery may cause a ﬁre or chemical burn. Keep the battery

away from children. Do not recharge, disassemble, heat above 212˚F (100˚C), or incinerate the

battery. Dispose of the used battery promptly and responsibly.

For more information, call Bose

customer service. Refer to the phone numbers on the inside

back cover of this guide.

ee operating

instructions for typ

es of

attery to b

e used

See operating

instructions for types of

battery to be used

Positive symbol

Tab

(a)

(b)

AWMDC_OG.book Page 15 Monday, May 5, 2003 11:03 AM

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Bose Acoustic Wave II CD Changer Información técnica Pagina 15