Bose ControlSpace Guía de instalación

ControlSpace® CC-16 Zone ControllerSafety Instructions&Install Guide

10DIP Switch SettingsTerminationThe CC-16 zone controller uses a 2-wire RS-485 network to communicate with the ESP-88sound processor. For optimum per

11Connecting the wiresThe CC-16 zone controller uses a standard 6-wire Eurostyle terminal block for power andnetwork connections.1. Connect the netwo

12WiringPower supplyThe CC-16 zone controller requires a minimum of 100mA at 8VDC. For convenience andconsistency, we recommend you place the power su

13Mounting the CC-16 zone controllerWarning: The CC-16 must be installed in a National Electric Code (NEC) approved,enclosed electrical wall box.After

14• Ensure that the power supply is wired correctly and plugged in• Try disconnecting other CC-16s if sharing a supply• Verify that the supply is DC a

15SpecificationsInput voltage8 - 18VDC, 100mAMax network cable length2000 feet (609m)Number of CC-16 zone controllers per ESP-88 Sound Processor15Dime

16WarrantyBose® Product Sales ConditionsLimited Warranty Policy and Conditions of SaleBose CorporationThe Mountain, Framingham, MA 01701What is covere

17Other Rights:EXCLUSIVE REMEDY:THIS LIMITED WARRANTY IS FULLY TRANSFERABLE PROVIDED THAT THE CURRENT OWNER FURNISHES THEORIGINAL PROOF OF PURCHASE FR

18

19

2For the intended audienceThis guide has been written for professional installers of sound systems.1. Read these instructions – for all components bef

20©2007 Bose Corporation, The Mountain,Framingham, MA 01701-9168 USA285042 AM Rev.01

3Information about products that generate electrical noiseThis equipment has been tested and found to comply with the limits for a Class B digital dev

4CautionCheck local regulations before installing the ControlSpace®CC-16 zone controller. Thebuilding code may require professional installation by a

5The Bose®ControlSpace®CC-16 zone controller is an elegant wall-mounted device designedto provide end-user control of ControlSpace systems. Custom pro

6Quick start1. Run power and network (2-wire) cables from the ESP-88 to the CC-16 mounting locationand install a mounting box.2. Set the DIP switches

7InstallationCablingThe CC-16 zone controller requires power and network cables. In some cases, these can besupplied over the same multi-conductor cab

8Installing the mounting boxInstall a dual-gang electrical box for each CC-16. Install the wall box so that it is flush or justbelow the surface of t

9The CC-16 zone controller has an 8-position DIP switch located on the back of the unit. TheDIP switches control addressing and termination settings.D