Bose ESP-00 Series II Guía de instalación descargar pdf (Pagina 18)

Page 18 User Guide English

Installation and Operating Guide pro.Bose.com

6. CC-16 and RS-232 connections

CC-16 Connector

The CC-16 connector is an RS-485 network connection for use with

Bose

CC-16 zone controllers. Using the supplied Euroblock 3-pin

labeled connector, up to 15 CC-16 zone controllers can be networked to

control the ESP processor or any device on the Bose ControlSpace

control network. An external power supply is required. Note that in

addition to wiring the A and B terminals, it is highly recommended to

connect the ground terminal from the ESP processor to each CC-16 zone

controller. The maximum distance from ESP processor to any CC-16 is

2000 feet (610 m).

RS-232 Connector

The RS-232 connector provides a DB-9 male connector (type DTE) for

communication between the ESP processor and other serial-controlled

devices including third-party control systems.

Figure 7. RS-232 Panel Connector Pinout

The default serial port settings are 38,400 baud, 8-bits length, 1 stop bit, no parity, and no ﬂow control. If required these settings can be

changed using ControlSpace

Designer

™

software.

The document ControlSpace

Serial Control Protocol (downloadable from pro.Bose.com) outlines all supported command strings and

functions available to control/query Bose ESP processors and PowerMatch

power ampliﬁers.

GPIO 1

DSP

GPIO 1

DSP

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

Bose ESP-00 Series II Guía de instalación Pagina 18