Bose Personalized Amplification System Especificaciones descargar pdf (Pagina 11)

Setup

Connecting a bass module to the power stand (optional)

The Bass/Amp 3 OUT jack on the power stand can adequately drive one or two Model B1

bass modules. Bass modules can be placed on the floor vertically or horizontally. Up to four

modules may be stacked when placed horizontally (

Figure 4).

CAUTION: Do not connect more than two Model B1 bass modules to the Bass/Amp 3 OUT

connector on the power stand. Driving more than two bass modules from the Bass/Amp 3 OUT

output will improperly load the amplifier in the power stand resulting in less than full system

performance.

Figure 4

Recommended bass

module orientations

Connecting one bass module

Insert one end of the bass module 4-wire cable into one of the jacks on the rear panel of the

bass module. Insert the other end of the 4-wire cable into the Bass/Amp 3 OUT jack on the

power stand connector panel.

Figure 5

Installation of one

bass loudspeaker

Bass modules can be placed

vertically or horizontally

Modules may be stacked in a column

of up to four, maximum

Bass/Amp 3 OUT

To connect, push the plug into the

jack and rotate it clockwise to lock

it (you will hear a soft click).

To disconnect, slide back the metal

tab on the body of the plug, rotate the

plug counterclockwise and pull it out

of the jack.

4-wire cable

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sin comentarios

Bose Personalized Amplification System Especificaciones Pagina 11