Bose Personalized Amplification System Especificaciones descargar pdf (Pagina 12)

Setup

Connecting two bass modules

Connect the first bass module to the power stand as shown in “Connecting one bass mod-

ule” on page 11.

Insert one end of the second bass module cable into the unused jack on the rear panel of the

first bass module. Insert the other end of the cable into one of the jacks on the rear panel of

the second bass module.

CAUTION: Do not connect more than two Model B1 bass modules to the Bass/Amp 3 OUT

connector on the power stand. Driving more than two bass modules from the Bass/Amp 3 OUT

output will improperly load the amplifier in the power stand resulting in less than full system

performance.

Note: Use only the supplied 4-wire speaker cable to connect bass modules to the power stand.

The power stand uses the signals on two of the four wires to automatically sense how many bass

modules are connected to it. DO NOT SUBSTITUTE the supplied cable with a 2-wire speaker

cable.

Figure 6

Installation of two bass

modules

Bass/Amp 3 OUT

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sin comentarios

Bose Personalized Amplification System Especificaciones Pagina 12